1-877-337-4177
This front upper combination control arm and ball joint set is designed to give you extra camber adjustment that you can't get with factory adjustments. This set is much faster to install then pressing out the old ball joint and pressing a new one in. The control arm is designed to meet or exceed factory specs and durability.
Fully adjustable and allows for range of Camber ± 3.0° Caster ±1.5°. Also allows for future adjustment if your alignment changes.
Caution: Do not pressurize the ball joint pocket with the grease gun. The grease fitting is for filling the pocket only. Fill until there is pressure in the handle of your grease gun then STOP. Only use manual grease guns to fill the ball joints. Using a battery or air assist grease gun can cause permanent damage and or premature failure of ball joint.
Note: Stamped arm When installing ball joint on smaller rim size if installed in all caster or negative camber position my cause rubbing with rim. Always check for proper clearance between all moving parts before moving vehicle. To prevent any damage to vehicle
APPLICATION(S):
WARRANTY: Alignment kits are warranted from manufacturers defects for the life of the vehicle. Warranty does not cover damage to parts due to improper installation or use. Warranty covers part replacement only. No refunds are given for warranty related issues and the warranty does not cover any labor costs or any other costs that were incurred.
